Differences

This shows you the differences between two versions of the page.

--- ltspice_manual [2025/06/21 13:51] – created np
+++ ltspice_manual [2025/06/22 14:10] (current) – 85.115.61.180
@@ Line 3: / Line 3: @@
 After the installation process, the software is ready to be used. When the program is launched, the following startup screen is displayed.
-foto
+{{ :ltspice.png?600 |}}
 From this screen, the following actions can be performed:
@@ Line 13: / Line 13: @@
   * Starting a new project
 In the context of this manual, a new project will be created. The figure below shows a blank schematic window, and now most of the other tools are available.
-Figure 57 shows the available tools for creating and editing a schematic. The tools, from left to right, have the following functions:
+{{ :ltspice2.png?600 |}}
+The figure above shows the available tools for creating and editing a schematic. The tools, from left to right, have the following functions:
   * Wire tool: used to draw electrical connections between components.
@@ Line 35: / Line 37: @@
   * Label Net:adds a net label, which names a wire so it can be referenced elsewhere in the circuit or for waveform plotting.
-foto
+The figure below shows the visualization of some of the basic components mentioned earlier used in LTspice
+{{ :ltspice3.png?nolink&600 |}}
-To start and configure the analysis, the green triangle in the top left corner of the toolbar must be pressed. When pressed, below window will open to add the details for the simulation. For this example, an instant transient simulation with a duration of one second is configured. For the full explanation of the analysis configuration, consult the manual that was previously mentioned. After simulation, the measurement screen will appear, allowing to measure and plot various data. When the probe measures the voltage at the output, a value of 16V appears on the measurement window.
+To start and configure the analysis, the green triangle in the top left corner of the toolbar must be pressed. When pressed, below window will open to add the details for the simulation. For this example, an instant transient simulation with a duration of one second is configured. For the full explanation of the analysis configuration, consult the manual that was previously mentioned. After simulation, the measurement screen will appear, allowing to measure and plot various data.
-Foto
+{{ :ltspice4.png?nolink&600 |}}